Data cabling installation is not just a plug but is a specific subject that needs understanding. Improper cabling can lead to many problems such as hardware failure, heat retention, and maintenance problems. Proper knowledge, tools, and training are required to install data cabling successfully. Investing time in proper planning and organizing of data cabling installation helps in maximizing its efficiency. In this article, tips for practical and affordable cable installation are explained so that it can help you to keep your network cable organized. You can give the needed care and attention to the data cables for network reliability and cable durability in the future.
An important rule to remember in data cabling installation is to measure twice before cutting. You can reduce expensive cable waste by carefully measuring the data cables. It not only prevents a tangled mess but also saves you a lot of time and money as every foot of waste data cables adds up.
Cable Length Matters
If you have to choose between exact cable length and extra cable length, then always opt for the former. Though it may seem resourceful to have longer data cables, it is not practical. The data cable will lose its quality which will affect its performance. A large data cable may not work or may not be reliable. The main reason for a messed up cabling usually is improper cable length. It is wise to use shorter data cables wherever possible. The best solution in this matter is to use customized data cables where you can get the exact cable length that you require without any excess that can go to waste.
Labeling cables seem to be a challenging and unnecessary chore, but it is a method that pays off in the long run. Remember when you have to test the circuits, and if you are short on time, then you will just plug and unplug a few patch cables quickly to test them out. Later when you have to reset them, it will become a problem if you do not know the default location of each data cable. To avoid this problem and to save time, label both ends of the data cable. Make sure that the label is consistent so that the next time either you or another installer will have no problems to decipher the location.
Separate Data Cables and Power Lines
Data cables are not as same as electrical wires so they cannot be bundled together. It does prevents not only any potential fire hazards but also optimizes performance. Power lines can interfere with the magnetic field inside data cables causing signal loss. It leads to slow data transmission speed. Power lines also generate heat that can minimize the performance of data cables. So at all costs, keep data cables and electrical lines separate during the time of installation.
Minimize Stretching of Data Cables
Do not hang data cables without any support. Gravity will induce stress on the data cable causing it to stretch and distort over time. It can also lead to network disconnect as the connectors can come loose when the cables are stretched. Use cable supports such as brackets or any device mounted on the wall that will keep the data cables of their worn weight. The good idea is to use Velcro ties rather than the standard plastic ties as they are easy to add, remove and reuse. Also do not pull hard on the cables during data cabling installation.
Do not overload the cable trays. Cable trays that are usually mounted on something can fall off and break if they are too heavy. Too many cables can also pose a safety problem as well as operational problems as you cannot remove unused cables without disturbing the other cables. Cables in the bottom can be crushed by the weight of cables if the tray is overloaded which can lead to a degraded signal.